Decoiling Equipment

RD2 -SW2- Dual Rim Drive/ Straightener Combo

2 in 1 combination of drum decoiling and roll feed straightening unit provide space saving and operation efficiency. Light in handling of fine wire use in 0.025” square pin in the electronic stamping industries. Single strip or double strips usage can be operated as all motors are independently controlled.

The drum speed is automatically controlled to provide a smooth constant flow of material and accommodate the changing coil diameter synchronized by analogue contact-less sensor. With easy positioning of roller and guide, this machine can handle most of the drum size and width in the market.

Quick and easy to adjust precision wire straightening unit with motorized roll feed easily straighten out the wire before it goes to the die. Once set, it will be ready to go without further adjustment through out the whole drum.

Most suitable for very tight floor space and install anywhere near the press.


  • 2-up in one construction
  • Drum speed via contact-less sensor control with speed gain control adjustment
  • Presetable speed control for Straightener unit
  • Inch control for pre-straightening
  • Quick and easy change of drum size and width
  • Floor space saving
  • Over-pull limit protection
  • Power-Off interlock protection
  • Easy operation


  • Higher load and speed on request
  • Single up or 4-up on request
  • Other voltage

Technical Data

Model RD2 -SW2
Drum diameter 400 - 600 mm
Drum width 150 - 360 mm
Rim linear speed 0 - 23 m/min
Max load/ Drum 300 kg
Wire size 0.025
No of rollers/ Side 2-axis (13 x 13)
Voltage single phase 220v/ 50hz